technology

Wrong electrical information circulated

Wrong electrical information circulated

Wrong electrical information circulated

Do not leave the laptop charging when it is full, as this will damage the battery

 In fact, this advice is what harms the battery and reduces its life. Whoever invented this idea does not distinguish between a laptop battery that is lithium-ion, and a car battery that is lead acid, and he also thinks that the laptop has an iron trans-charger inside with a calendar bridge and an ampere scale Just as the car battery was charged in the old days and not a sophisticated electronic charging circuit that charges the battery and protects it in an ideal way, scientifically to preserve the laptop battery and the mobile battery, leave it in charging as much as possible, and charge it whenever it decreases, even if a little, and whoever does not like this talk should review the instructions Charging lithium-ion batteries.

Leave the mobile battery drained to zero, then charge it to activate it

In fact, this advice is what kills the mobile battery.
This advice was for one type of battery, which is nickel-cadmium (NiCd) batteries, because these batteries contain a charging memory that causes a problem in dealing with it, so it is charged at once, and discharged at once.
There are nickel-metal hydrate (NiMh) batteries that have a small memory, so it is recommended to empty them every few times of use.
As for the mobile battery, it is (lithium-ion) and it does not contain a memory for charging and its life decreases every time you empty it to less than 15% of its capacity.

Do not install thick wires for LEDs, as they waste electricity. Install thin wires, especially intercom wires. 

On the contrary, it is thin wires that waste electricity because the thinner the wire, the greater its resistance to the passage of electricity within it, and resistance means heat dissipation, that is, the loss of energy in the air that we do not benefit from. The thicker the wire the better.

If you want to install an electric switch for a water heater, then install the switch on the cold line (neutral - nitrate), then it will bear more current.

When you separate the cold line (nitrer) from the heater, you leave the protective line within it permanently. If there is any leakage of the insulation inside the heater, you will turn the heater into a free killing device.
As the presence of the cold line will absorb the current of the heating line, and cutting the cold line will make the whole heater body hot, and therefore any touch to it will have serious consequences.
On the other hand, if there is any problem and you want to disconnect the electricity from the heater, the switch will not disconnect it and the danger will remain.

Ryan Sheikh Mohammed

Deputy Editor-in-Chief and Head of Relations Department, Bachelor of Civil Engineering - Topography Department - Tishreen University Trained in self-development

Related articles

Go to top button
Subscribe now for free with Ana Salwa You will receive our news first, and we will send you a notification of each new not نعم
Social Media Auto Publish Powered By: XYZScripts.com